HWiNFO Stream Deck Plugin
âš âš Major refactor landed in pre-release v2.0.0, plugin code open sourced, remote monitoring infrastructure support âš âš
Thank you & Looking for Maintainers
Thank you everyone who has used and enjoyed this plugin. It started as a passion project and I continue to use it day to day. I am happy to finally release the full source on GitHub. When I first built it, it was closed under agreement with the HWiNFO64 project. They have since opened up the shared memory interface and now the plugin is freely open.
I haven't had the time to dedicate to this project in some time and appreciate everyone for hanging in there. I hope to work with some of you who are eager to take the project over. I am happy and ready to hand over the reigns. If there are development questions I'm happy to share my thoughts on the code and structure that exists.
-Shayne
NOTICE: HWiNFO64 must be run in Sensors-only mode for the plugin to work.
Enabling Support in HWiNFO64
NOTICE: It has been reported that running the "portable" version of HWiNFO64 doesn't work with this plugin. The recommendation is to run the version with the installer until I can figure out the issue.
-
Download and install HWiNFO64, if you haven't already
-
Choose "Sensors-only" mode
-
Click "Settings"
-
Ensure "Shared Memory Support" is checked
-
(Optional) Recommended launch settings
-
Click "OK" then, "Run"
If the plugin doesn't work immediately, you may have to quit and reopen HWiNFO64.
From the system tray:
Install and Setup the Plugin
-
Download the latest pre-compiled plugin
When upgrading, first uninstall: within the Stream Deck app choose "More Actions..." (bottom-right), locate "HWiNFO" and choose "Uninstall". Your tiles and settings will be preserved.
-
Double-click to install the plugin
-
Choose "Install" went prompted by Stream Deck
-
Locate "HWiNFO" under "Custom" in the action list
-
Drag the "HWiNFO" action from the list to a tile in the canvas area
-
Configure the action to display the sensor reading you wish
